Metro Post

Locations

* Click to view the location page

Metro Post

Handrail posts that can be secured to holes in the decking panels; a safety-oriented design with minimal protrusions

It is easy to install and remove through the holes in the decking, and the support posts can be securely fastened with a single touch. The handrail protrudes very little, making it safe.

Catalogs

Features

With a hot-dip galvanized finish that offers excellent corrosion resistance, it withstands wind and rain on-site.
Designed so that the tip claw and the support holder face the same direction, it can withstand strong impacts.
These products have been certified by the Temporary Construction Equipment Association, so you can use them with confidence on your job sites.

[Installation Instructions]
① Tilt the handrail holder so that the front side is facing you, and insert one end of the tab into the hole.
② Pull it toward you to lift it up, then insert the tab to secure it in place.
[Installation Instructions]
③ Use a ratchet (21 mm flat drive) to securely tighten the support post to a torque of at least 39.2 N·m (400 kgf/cm).
(It is easier to align the pipe if you rest the single-wall pipe against the pipe holder before tightening.)
[Installation Instructions]
④ Insert the single-wall pipe into the handrail holder and tighten it.
Set the tightening torque to approximately 29.4–39.2 N/m (300–400 kgf/cm).